Retropubic operations for stress urinary incontinence


Introduction

Since 1949, when Marshall et al. first described retropubic urethrovesical suspension for the treatment of stress urinary incontinence (SUI), retropubic procedures have proved to be consistently curative. Although numerous terminologies and variations of retropubic repairs have been described, the basic goal remains the same: to suspend and stabilize the anterior vaginal wall, and thus the bladder neck and proximal urethra, in a retropubic position. This prevents their descent and allows urethral compression against a stable suburethral layer. Selection of a retropubic approach (versus a vaginal approach) depends on many factors, such as the need for laparotomy or laparoscopy for other pelvic prolapse or disease, the amount of pelvic organ prolapse, the status of the intrinsic urethral sphincter mechanism, the age and health status of the patient, any history of previous sling or mesh complications, the patient’s desire for future fertility, the preference and expertise of the surgeon, and the preferences of an informed patient.

Historically, few data differentiated one retropubic procedure from another. The three most studied and popular retropubic procedures were the Burch colposuspension, the Marshall–Marchetti–Krantz (MMK) procedure, and the paravaginal defect repair. We no longer perform the MMK procedure, so this operation will not be described. We prefer the Burch colposuspension for urodynamic stress incontinence with bladder neck hypermobility and adequate resting urethral sphincter function, and sometimes combine it with a paravaginal defect repair when the patient has stage II or III anterior vaginal prolapse or when a concurrent sacrocolpopexy is to be done. The surgical techniques described here are contemporary modifications of the original operations: described the modified Burch colposuspension; and the paravaginal defect repair was described by and (paravaginal repair), and by and (vaginal obturator shelf repair). Although less critically studied, the paravaginal defect repair was regionally popular and widely performed in the United States. The operations described do not represent one correct technique, but a commonly used and proven method.

This chapter describes retropubic suspension procedures that use an abdominal wall incision for direct access into the space of Retzius. The use of laparoscopy, robotic assistance, and mini-incision laparotomy to enter the retropubic space and perform these and similar procedures is usually preferred, and is based on whether other concurrent surgeries need to be done and on what is most desired by and possible for the surgeon and the informed patient. For a review of retropubic anatomy, see .

Indications for retropubic procedures

Retropubic urethrovesical suspension procedures are indicated for women with the diagnosis of urodynamic SUI and a hypermobile proximal urethra and bladder neck. It is now most frequently used for patients with SUI who have contraindications to or who do not desire a mesh sling, or for those having concomitant laparoscopic or open procedures. Although retropubic procedures can be used for intrinsic sphincter deficiency with urethral hypermobility, other, more obstructive, operations such as a retropubic bladder neck or midurethral sling probably yield better long-term results.

To diagnose urodynamic SUI, clinical and urodynamic (simple or complex) tests must be performed to evaluate bladder filling, storage, and emptying. Clinically, the urethra is shown to be incompetent by visually observing loss of urine simultaneous with increases in intraabdominal pressure (a positive cough stress test). Urodynamics may also be used for diagnosis. Abnormalities of bladder-filling function, such as detrusor overactivity, can coexist with urethral sphincter incompetence in up to 30% of patients and may be associated with a lower cure rate after retropubic surgery.

Women with SUI should generally have a trial of conservative therapy before corrective surgery is offered. Conservative treatment comes in the form of pelvic muscle exercises, bladder retraining, pharmacologic therapy, and mechanical devices such as pessaries. Eligible and willing postmenopausal patients with atrophic urogenital changes should be prescribed vaginal estrogen before surgery is considered.

Surgical techniques

Operative setup and general entry into the retropubic space

The patient is supine with the legs supported in a slightly abducted position, allowing the surgeon to operate with one hand in the vagina and the other in the retropubic space. The vagina, perineum, and abdomen are sterilely prepped and draped in a fashion that permits easy access to the lower abdomen and vagina. A three-way 16- or 20-French Foley catheter with a 20- to 30-mL balloon is inserted sterilely into the bladder and kept in the sterile field. The drainage port of the catheter is left to gravity drainage, and the irrigation port is connected to sterile water, with or without blue dye, as desired. One perioperative intravenous dose of an appropriate antibiotic should be given as prophylaxis against infection within 1 hour before the incision is made. Appropriate thromboprophylaxis is given.

A small Pfannenstiel incision is made. During intraperitoneal surgery, the peritoneum is opened, the surgery is completed, and the cul-de-sac is plicated, if necessary. The retropubic space is then exposed. Staying close to the back of the pubic bone, the surgeon’s hand is introduced into the retropubic space, and the bladder and urethra are gently moved downward. Sharp dissection is not usually necessary in primary cases. To aid visualization of the bladder, 100 mL sterile water with methylene blue or indigo carmine dye may be instilled into the bladder after the catheter drainage port is clamped.

If the surgery is being done with laparoscopy or with robotic assistance, the intraperitoneal ports are placed as preferred by the surgeon, and the bladder is filled with 200 to 300 mL sterile water. An incision in the anterior abdominal wall peritoneum 2 to 3 cm above the bladder is made between the umbilical ligaments and, using mostly blunt dissection, the bladder is pushed downward, exposing the retropubic space. The surgeon should mostly dissect in the midline toward the pubic symphysis, then bluntly dissect bilaterally until both Cooper’s ligaments and obturator internus muscles are seen and cleared of areolar tissue. Suturing and knot-tying are done endoscopically using standard techniques noted later.

If previous retropubic sling or other bladder neck suspension procedures have been performed, dense adhesions and/or mesh fragments from the anterior vaginal and bladder wall and urethra to the symphysis pubis are often present. These adhesions and/or mesh should be dissected sharply from the pubic bone until the anterior bladder wall, urethra, and vagina are free of adhesions and are mobile. Mesh strips from prior slings can be removed if necessary. If identification of the urethra or lower border of the bladder is difficult, one may perform a small cystotomy, which, with a finger inside the bladder, helps to define the bladder’s lower limits for easier dissection, mobilization, and elevation.

Burch colposuspension

After the retropubic space is entered, the urethra and anterior vaginal wall are depressed. Minimal dissection should be performed in the midline over the urethra or at the urethrovesical junction, thus protecting the delicate musculature of the urethra from surgical trauma. Attention is directed toward the tissue on either side of the urethra. The surgeon’s nondominant hand is placed in the vagina, palm facing upward, with the index and middle fingers on each side of the proximal urethra. Most of the overlying fat should be cleared away, using a swab mounted on a curved forceps. This dissection is accomplished with forceful elevation of the surgeon’s vaginal finger until glistening white periurethral fascia and vaginal wall are seen ( Fig. 15.1 ). This area is extremely vascular, with a rich, thin-walled venous plexus that should be avoided, if possible. The position of the urethra and the lower edge of the bladder is determined by palpating the Foley balloon and by partially distending the bladder to define the rounded lower margin of the bladder as it meets the anterior vaginal wall.

Fig. 15.1, Dissection of the lateral retropubic space. After forceful elevation of the surgeon’s finger placed vaginally, the fat overlying the glistening white periurethral fascia is cleared in preparation for suture placement.

Once dissection lateral to the urethra is completed and vaginal mobility is judged to be adequate by using the vaginal fingers to lift the anterior vaginal wall upward and forward, sutures are placed. No. 0 or 1 delayed absorbable or nonabsorbable suture is placed as far laterally in the anterior vaginal wall as is technically possible. We apply two sutures of No. 0 braided polyester on an SH needle (Ethibond; Ethicon, Inc., Somerville, NJ) bilaterally, using double bites for each suture. The distal suture is placed approximately 2 cm lateral to the proximal third of the urethra. The proximal suture is placed approximately 2 cm lateral to the bladder wall at or slightly proximal to the level of the urethrovesical junction. When placing the sutures, one should take a full thickness of vaginal wall, excluding the epithelium, with the needle parallel to the urethra ( Fig. 15.2 , inset). This maneuver is best accomplished by suturing over the surgeon’s vaginal finger at the appropriate selected sites. On each side, after the two sutures are placed, they are passed through the pectineal (Cooper’s) ligament so that all four suture ends exit above the ligament ( Fig. 15.2 ). Before the sutures are tied, a 1 × 4 cm strip of Gelfoam may be placed, if desired, between the vagina and obturator fascia below the Cooper’s ligament to aid adherence and hemostasis.

Fig. 15.2, Technique of Burch colposuspension. After the two sutures are placed on each side, they are passed through the pectineal (Cooper’s) ligament, so that all four suture ends exit above the ligament to facilitate knot tying. Inset: When placing the sutures, one should take a full thickness of vaginal wall, excluding the epithelium, with the needle parallel to the urethra. This maneuver is best achieved by suturing over the finger placed vaginally.

As noted previously, this area is extremely vascular, and visible vessels should be avoided when possible. When excessive bleeding occurs, it can be controlled by direct pressure, sutures, application of thrombotic agents, or vascular clips. Less severe bleeding usually stops with direct pressure and after tying the suspension sutures.

After all four sutures are placed in the vagina and through the Cooper’s ligaments, the assistant ties first the distal sutures and then the proximal ones, while the surgeon elevates the vagina with the vaginal hand. When tying the sutures, one does not have to be concerned about whether the vaginal wall meets the Cooper’s ligament, so one should not place too much tension on the vaginal wall. A suture bridge is usually found between the two points. After the sutures are tied, one can easily insert two fingers between the pubic bone and the urethra, thus preventing compression of the urethra against the pubic bone. Vaginal fixation and urethral support depend more on fibrosis and scarring of periurethral and vaginal tissues over the obturator internus and levator fascia than on the suture material itself.

demonstrates our technique for laparoscopic Burch colposuspension

Paravaginal defect repair

The object of the paravaginal defect repair is to reattach, bilaterally, the anterolateral vaginal sulcus with its overlying endopelvic fascia to the pubococcygeus and obturator internus muscles and fascia at the level of the arcus tendineus fasciae pelvis. The retropubic space is entered, and the bladder and vagina are depressed and pulled medially to allow visualization of the lateral retropubic space, including the obturator internus and levator muscles, and the fossa containing the obturator neurovascular bundle. Blunt dissection can be carried dorsally from this point until the ischial spine is palpated. The arcus tendineus fasciae pelvis is often visualized as a white band of tissue running over the pubococcygeus and obturator internus muscles from the back of the lower edge of the symphysis pubis toward the ischial spine. A lateral paravaginal defect representing avulsion of the vagina off the arcus tendineus fasciae pelvis or of the arcus tendineus fasciae pelvis off the obturator internus muscle may be visualized ( Fig. 15.3 ).

Fig. 15.3, Lateral paravaginal defect and technique of paravaginal defect repair. Five or six sutures are placed, first through the full thickness of the vagina (excluding the vaginal epithelium) and then into the obturator internus fascia or arcus tendineus fasciae pelvis, 3–4 cm below the obturator fossa.

The surgeon’s nondominant hand is inserted into the vagina. While gently retracting the vagina and bladder medially, the surgeon elevates the anterolateral vaginal sulcus. Starting near the vaginal apex, a suture is placed, first through the full thickness of the vagina (excluding the vaginal epithelium) and then deep into the obturator internus fascia or arcus tendineus fasciae pelvis, 1 to 2 cm anterior to its origin at the ischial spine. After this first stitch is tied, additional (3–5) sutures are placed through the vaginal wall and overlying fascia and then into the obturator internus at about 1-cm intervals toward the pubic ramus ( Fig. 15.3 , inset). The most distal sutures should be placed as close as possible to the pubic ramus, into the pubourethral ligament; alternatively, Burch colposuspension sutures can be placed bilaterally at the level of the bladder neck and urethra if the patient has SUI. No. 2-0 or 0 delayed absorbable or nonabsorbable suture on a medium-sized, tapered needle is usually used for the paravaginal repair.

This procedure leaves free space between the symphysis pubis and the proximal urethra, but also provides secure support so that rotational descent of the proximal urethra and bladder base is prevented with sudden increases in intraabdominal pressure. According to , this avoids overcorrection and fixation of the periurethral fascia, which might compromise the functional movements of the urethra and bladder base and lead to obstruction and voiding difficulty. This principle may explain why the paravaginal defect repair usually results in spontaneous voiding on the first or second postoperative day. In fact, the vaginal obturator shelf repair was used to correct dysfunctional voiding symptoms in patients after previous retropubic surgery. in Chapter 19 demonstrates the technique of laparoscopic paravaginal repair.

General intraoperative and postoperative procedures

To make sure that intravesical suture placement or ureteral obstruction has not occurred, cystoscopy (or a small cystotomy) should be performed to document ureteral patency and the absence of intravesical sutures after retropubic procedures. Intravenous injection of an appropriate dye before cystoscopy aids visualization of urine from the ureters.

Closed suction drains in the retropubic space are used only as necessary when hemostasis is incomplete and there is concern about postoperative hematoma. The bladder is routinely drained with a suprapubic or transurethral catheter for 1 to 2 days. After that time, the patient is allowed to begin voiding trials, and postvoid residual urine volumes are checked, either with the suprapubic catheter or by intermittent self-catheterization.

You're Reading a Preview

Become a Clinical Tree membership for Full access and enjoy Unlimited articles

Become membership

If you are a member. Log in here